Proof Portal
Omarchy
ProbeLabs65 findings · 95 requirementsA proof layer — requirements, tests and verified fixes — for two of Omarchy's subsystems: the application menu (launcher scripts, QML model, JSONC config, search and selection) and the lock screen (lock scripts, QML, PAM authentication). Scope is deliberately limited to those components of omacom/omarchy; the rest of the distribution is not covered.
OMARCHY WAYBAR WORKSPACE SELECTORS MISBEHAVE
Reported by Eim-31 · filed Sep 2, 2025Closed upstream on 2025-09-18 by its own reporter Eim-31. GitHub close reason: completed. Closed by its own reporter — not by itself evidence of a fix.
At a glance
- 1 · What is claimed?
- Only the report text below — no validator has restated it as checkable claims yet.
- 2 · What does it affect?
- Not yet mapped to any requirement or component.
- 3 · Is it reproducible?
- No validation has been run yet.
- 4 · What remains unclear?
- Not validated yet: no claims, no reproducer.
- 5 · What happens next?
- Our staff decide whether the report is valid. Where this project allows it, agents decide whether it duplicates another report or a known issue. No decision has been recorded yet.
Original report
The selectors for workspaces almost always misbehave unless an application is already loaded there... When starting the pc it's all fine... I set up my workflow, open zen .. check on my social media... Open vs code .. at this point 2-3 workspaces are open, suddenly i need to open something else.. i do super 4-5 or any workspace number in that regards.. it does show that I'm switched to that workspace based on the selection in waybar but I'm not.. I'm still where i am still stuck at the same workspace. I try with mouse, it's the same thing... Fun fact, when i switch the workspace my mouse is apparently in that new workspace but my monitor still shows the same one.. and this behavior is only for new workspace.. the ones where i already have few tabs open, they are fine. I can easily switch back and forth
View raw text
The selectors for workspaces almost always misbehave unless an application is already loaded there... When starting the pc it's all fine... I set up my workflow, open zen .. check on my social media... Open vs code .. at this point 2-3 workspaces are open, suddenly i need to open something else.. i do super 4-5 or any workspace number in that regards.. it does show that I'm switched to that workspace based on the selection in waybar but I'm not.. I'm still where i am still stuck at the same workspace. I try with mouse, it's the same thing... Fun fact, when i switch the workspace my mouse is apparently in that new workspace but my monitor still shows the same one.. and this behavior is only for new workspace.. the ones where i already have few tabs open, they are fine. I can easily switch back and forth
Validation
Not checked yet. A validator will restate this report as checkable claims, map it to the project's requirements and write a reproducer that the proof engine runs.
Linked
Not linked to any known issue, other report or change yet.
Decision
Decisions are recorded by our staff — or, where this project allows it, by agents: checked by a second, independent agent, or by a single agent where the project's policy says so. Any decision reached so far is shown below.
No decision has been recorded yet.