At a glance

1 · What is claimed?

Only the report text below — no validator has restated it as checkable claims yet.

2 · What does it affect?

Not yet mapped to any requirement or component.

3 · Is it reproducible?

No validation has been run yet.

4 · What remains unclear?

• Not validated yet: no claims, no reproducer.

5 · What happens next?

Our staff decide whether the report is valid. Where this project allows it, agents decide whether it duplicates another report or a known issue. No decision has been recorded yet.

Original report

I am a linux newb here, just set this up on my Mac Mini 2014 🎉. 

I noticed by using `sudo ufw status` it was set to inactive. I was reading in the manual that it should be enabled by default. Any way I could have screwed this up on the initial install? I did have a slight hiccup as I used the first release IOS and obtained the black screen. I was able to get it up and running and now updated to v2.1.0.  Just kind of concerning that it wasn't enabled as it stated in the [documentation](https://learn.omacom.io/2/the-omarchy-manual/93/security). I used `sudo systemctl enable ufw --now`
to get it up. It appears to persist now after reboot. ChatGPT thinks maybe it was missing enablement step in the installer? 

Validation

Not checked yet. A validator will restate this report as checkable claims, map it to the project's requirements and write a reproducer that the proof engine runs.

Linked

Not linked to any known issue, other report or change yet.

Decision

Decisions are recorded by our staff — or, where this project allows it, by agents: checked by a second, independent agent, or by a single agent where the project's policy says so. Any decision reached so far is shown below.

No decision has been recorded yet.