**System details:** Dell Inspiron 3585 (BIOS 1.15.0), AMD Ryzen 5 2500U / Radeon Vega (Raven Ridge), AMD Raven USB 3.1 xHCI (`1022:15e0`, `1022:15e1`), Omarchy 4.0.4-1, linux-omarchy 7.2.5-3 (`7.2.5-3-omarchy`), Hyprland 0.56.2

On this Omarchy laptop a desk USB hub enumerates on boot, the keyboard and mouse appear for a few seconds, then the **entire hub tree disconnects** and does not come back. Hyprland never keeps the devices because the kernel has already dropped them.

The same hub and devices work on another laptop. HDMI to the Iiyama PL3494WQ works on this machine. This is not an input-config / Hyprland ignore issue.

## Devices on the hub (when it enumerates)

- GenesysLogic USB2.0 Hub `05e3:0610` (and on a good USB3 connect also `05e3:0612`)
- Realtek 4-port hub `0bda:5420` / USB3 `0bda:0420`
- Realtek USB gigabit LAN `0bda:8153` (`r8152-cfgselector` resets it during probe)
- Logitech Unifying receiver `046d:c52b` → MX Master 3 (`046d:4082`)
- Das Keyboard P13 `24f0:0105`
- Logitech C270 webcam `046d:0825`
- AudioQuest DragonFly Black `21b4:0083`
- Nested Terminus hubs `1a40:0101`

Typical path: `usb 3-1` → `3-1.1` → `3-1.1.3` → keyboard/mouse/webcam/DAC.

## Steps to reproduce

1. Boot Omarchy with the hub already plugged into a laptop USB port (left-side AMD xHCI `04:00.4`, port `usb3-port1`).
2. Watch kernel USB: hub and HID devices appear.
3. Within ~4–15 seconds the whole `usb 3-1` tree disconnects.
4. After that every external USB port stays `state=not attached`. HDMI can still come up independently.

Reproduced across multiple boots (2026-09-16 evening and 2026-09-17 morning/afternoon). One boot (10:54–12:55) never saw the hub at all.

## Expected

Hub stays enumerated. Das Keyboard P13 and Logitech MX Master 3 remain as `/dev/input` devices and show up in `hyprctl devices`.

## Actual

This boot:

- 12:57:19 hub connects on `usb 3-1` (GenesysLogic `05e3:0610`)
- MX Master 3 is created (`logitech-hidpp-device`)
- 12:57:23 entire tree disconnects (no over-current)
- 12:57:26 reconnects, MX Master 3 again
- 12:57:36 entire tree disconnects and never returns
- `lsusb` afterwards is only internal devices (webcam, fingerprint, BT, card reader)
- `hyprctl devices` shows only the laptop keyboard/touchpad
- After reseating, HDMI-A-1 (Iiyama PL3494WQ 3440x1440) is connected; every external USB port is still `not attached`

No `over-current`, no `unable to enumerate`, no `error -71`. Clean `USB disconnect` of the root hub device.

`r8152-cfgselector` resets the dock ethernet (`0bda:8153`) during the same window as the cascade disconnect.

On 2026-09-16 19:46 the hub once enumerated as USB3 on the other controller (`usb1-2` / `usb2-2`, GenesysLogic `05e3:0612` + Realtek `0bda:0420`) and the Das Keyboard appeared; later reconnects on `usb 3-1` were USB2-only and still dropped.

## Logs (expire 24h)

- USB timeline: https://logs.omarchy.org/t4xjFF
- `omarchy-debug --no-sudo --print`: https://logs.omarchy.org/6WOw3g

## Notes

Not a duplicate of #10453 (Thunderbolt module vs firmware dock) or #11908 (USB-C DP-alt / UCSI after suspend). This Dell has no Type-C class/UCSI; video is native HDMI-A-1. The failure is AMD Raven `xhci_hcd` dropping a GenesysLogic + Realtek nested hub tree.