Proof Portal
Omarchy
ProbeLabs65 findings · 95 requirementsA proof layer — requirements, tests and verified fixes — for two of Omarchy's subsystems: the application menu (launcher scripts, QML model, JSONC config, search and selection) and the lock screen (lock scripts, QML, PAM authentication). Scope is deliberately limited to those components of omacom/omarchy; the rest of the distribution is not covered.
Tailscale not automatically connecting after fresh install of Omarchy 3.6.0
Reported by eddownes · filed Apr 23, 2026Closed upstream on 2026-04-23 by commit 5f7a5772831d (closed by dhh). GitHub close reason: completed.
At a glance
- 1 · What is claimed?
- Only the report text below — no validator has restated it as checkable claims yet.
- 2 · What does it affect?
- Not yet mapped to any requirement or component.
- 3 · Is it reproducible?
- No validation has been run yet.
- 4 · What remains unclear?
- Not validated yet: no claims, no reproducer.
- 5 · What happens next?
- Our staff decide whether the report is valid. Where this project allows it, agents decide whether it duplicates another report or a known issue. No decision has been recorded yet.
Original report
System details
XPS 16 2026 OLED
What's wrong?
This is my first bug report, and I am not even sure it's a bug, just trying to help :)
Computer: XPS 16 2026 w/ OLED
Mods: Samsung 9100 Pro Gen 5 m.2 SSD
Fresh update of BIOS firmware
Fresh install of Omarchy 3.6.0
After initial install and reboot, I proceeded to set things up as normal. When I installed Tailscale, I expected the regular process that I was used to: Install > Service > Tailscale
The expected behavior was that at the end of the install there would be a link to ctrl click to connect to Tailscale. Instead, I had a "Done! Press any key to close..." message.
I closed the terminal and went to the Tailscal website and get the install curl script.
Did not do a fresh second install to try to replicate, so I do not know if this was just a one-time fluke.
Hope this helps!
View raw text
### System details XPS 16 2026 OLED ### What's wrong? This is my first bug report, and I am not even sure it's a bug, just trying to help :) Computer: XPS 16 2026 w/ OLED Mods: Samsung 9100 Pro Gen 5 m.2 SSD Fresh update of BIOS firmware Fresh install of Omarchy 3.6.0 After initial install and reboot, I proceeded to set things up as normal. When I installed Tailscale, I expected the regular process that I was used to: Install > Service > Tailscale The expected behavior was that at the end of the install there would be a link to ctrl click to connect to Tailscale. Instead, I had a "Done! Press any key to close..." message. I closed the terminal and went to the Tailscal website and get the install curl script. Did not do a fresh second install to try to replicate, so I do not know if this was just a one-time fluke. Hope this helps!
Validation
Not checked yet. A validator will restate this report as checkable claims, map it to the project's requirements and write a reproducer that the proof engine runs.
Linked
Not linked to any known issue, other report or change yet.
Decision
Decisions are recorded by our staff — or, where this project allows it, by agents: checked by a second, independent agent, or by a single agent where the project's policy says so. Any decision reached so far is shown below.
No decision has been recorded yet.