Proof Portal

Sign in
Project overview

Omarchy

ProbeLabs65 findings · 95 requirements

A proof layer — requirements, tests and verified fixes — for two of Omarchy's subsystems: the application menu (launcher scripts, QML model, JSONC config, search and selection) and the lock screen (lock scripts, QML, PAM authentication). Scope is deliberately limited to those components of omacom/omarchy; the rest of the distribution is not covered.

Inbox
ReportR-4394GitHub issuePublicReceived

opencode stuck in infinite spinner after reboot until package reinstall + exec bash

Reported by AndrijaSkontra · filed May 13, 2026Closed upstream on 2026-05-15. GitHub close reason: completed. No closing PR or commit is recorded — "completed" alone is not evidence of a fix.

Open at source
Received and recorded verbatim. Nothing has been checked yet.

At a glance

1 · What is claimed?
Only the report text below — no validator has restated it as checkable claims yet.
2 · What does it affect?
Not yet mapped to any requirement or component.
3 · Is it reproducible?
No validation has been run yet.
4 · What remains unclear?
  • Not validated yet: no claims, no reproducer.
5 · What happens next?
Our staff decide whether the report is valid. Where this project allows it, agents decide whether it duplicates another report or a known issue. No decision has been recorded yet.

Original report

opencode stuck in infinite spinner after reboot until package reinstall + exec bashrevision 1 · captured 2026-10-04 11:56 UTC via poll

System details

Omarchy 3.8.

What's wrong?

Every time I reboot my PC and try to launch opencode from the terminal, it gets stuck in an infinite loading spinner and never opens.

Temporary workaround:
1. Run:
pacman -S opencode

Even though opencode is already installed, reinstalling it is required.

  1. After reinstalling, run:

exec bash

Only after these two steps does opencode start working normally again.

Steps to reproduce:
1. Boot/reboot the PC
2. Open terminal
3. Run:
opencode
4. Observe infinite spinner

Expected behavior:
opencode should launch normally after boot without requiring reinstall or restarting the shell.

Actual behavior:
opencode hangs indefinitely until reinstalling the package and running exec bash.

View raw text
### System details

Omarchy 3.8.

### What's wrong?

Every time I reboot my PC and try to launch `opencode` from the terminal, it gets stuck in an infinite loading spinner and never opens.

Temporary workaround:
1. Run:
   pacman -S opencode

Even though `opencode` is already installed, reinstalling it is required.

2. After reinstalling, run:
   exec bash

Only after these two steps does `opencode` start working normally again.

Steps to reproduce:
1. Boot/reboot the PC
2. Open terminal
3. Run:
   opencode
4. Observe infinite spinner

Expected behavior:
`opencode` should launch normally after boot without requiring reinstall or restarting the shell.

Actual behavior:
`opencode` hangs indefinitely until reinstalling the package and running `exec bash`.

Validation

Not checked yet. A validator will restate this report as checkable claims, map it to the project's requirements and write a reproducer that the proof engine runs.

Linked

Not linked to any known issue, other report or change yet.

Decision

Decisions are recorded by our staff — or, where this project allows it, by agents: checked by a second, independent agent, or by a single agent where the project's policy says so. Any decision reached so far is shown below.

No decision has been recorded yet.